Setting Of Search Port; (Advanced[0]Search Port); Return To Default Settings (Advanced[!]Restore Default Setting); Return To Main Menu (Advanced[Q]Return To Main Menu) - Eiki EIP-3000N Setup Manual

Setting of Search Port

(ADVANCED[0]Search Port)

Sets the port number used when searching for the
projector from the network.
advanced>0
Please Enter Port Number for Search from Computer.
Valid range : 1025 to 65535
Search Port : 9300
Please Enter : 9301
(change) —> 9301
1 1 1 1 1 Enter "0" and press the "Enter" key.
2 2 2 2 2 Enter numerical value and press the "Enter" key.
Display set numerical value (*).
Note
• Set according to need. Normally, use with the fac-
tory default setting.
Return to Default Settings
(ADVANCED[!]Restore Default
Setting)
Returns all menu setting values to the default state.
advanced>!
Restore All Setting to Default(y/n)? y
— User Setting Initialized —
1 1 1 1 1 Enter "!" and press the "Enter" key.
2 2 2 2 2 Enter "y" and press the "Enter" key.
Note
• If the values for IP Address, Subnet Mask or Gate-
way of the projector have been returned to the
default settings via Telnet, the computer cannot
be connected to the projector depending on the
computer's network settings.
Setting up the Projector Using RS-232C or Telnet
Return to Main Menu
(ADVANCED[Q]Return to Main Menu)
Returns to the main SETUP MENU.
advanced>q
---------------------------------SETUP MENU--------------------------------
1
[1]IP Address
[4]User Name
[6]RS-232C Baud Rate [7]Projector Name [8]DHCP Client
[A]Advanced Setup
2
[V]View All Setting
*
setup>
1 1 1 1 1 Enter "q" and press the "Enter" key.
Returns to the SETUP MENU.
1
2
[2]Subnet Mask [3]Default Gateway
[5]Password
[D]Disconnect All
[S]Save & Quit [Q]Quit Unchanged
1
27