Operation; Start The Machine; Stop The Machine; Adjust The Length Of The Cutting Line - GreenWorks STA805 Operator's Manual

EN
5. Tighten the auxiliary handle with the knob (3).
10

OPERATION

Before you operate the machine, read and understand the
safety regulations and the operation instructions.
Be careful when you operate the machine.
10.1

START THE MACHINE

Use only approved outdoor extension cords.
1. Put the extension cord through the slot on the rear handle
and put it underneath the cord retainer (3).
2. Attach the outlet end (4) of an extension cord to the plug
(2) on the rear of the machine.
3. Push the trigger (1) to start the machine.
IMPORTANT
WARNING
NOTE
1
2
3
4
English
10.2

STOP THE MACHINE

1. Release the trigger to stop the machine.
10.3 ADJUST THE LENGTH OF THE
CUTTING LINE
The machine has an auto-feed head. It will damage the
machine if you hit the head to try to advance the line.
If the cutting line does not automatically advance, it can be
tangled or empty.
1. When the machine is on, release the trigger.
2. Wait two seconds, push the trigger again.
3. Resume trimming.
The line will extend approximately 0.4 in. with each stop
and start of the switch trigger until the line reaches the cut-
off blade and the cut-off blade cuts the excess length.
10.4 ADJUST THE LENGTH OF THE
CUTTING LINE MANUALLY
1. Stop the machine. Remove the battery from the unit.
2. Push the spool retainer button and pull on cutting line to
manually advance the cutting line.
3. After you extend new cutter line, always return the
machine to its normal position before you start it again.
10.5

OPERATION TIPS

Keep clearance between the body and the machine.
Do not operate the machine without guard in place.
Do these tips when you use the machine
• Keep a firm hold with the two hands on the machine
while you operate the machine.
• Cut tall grass from the top down.
8
NOTE
NOTE
NOTE
WARNING
WARNING