Attach The Edge Guide; Attach The Guard; Attach The Auxiliary Handle; Install The Battery Pack - GreenWorks ST40B01 Operator's Manual

WARNING
• If the parts are damaged, do not use the machine.
• If you do not have all the parts, do not operate the
machine.
• If the parts are damaged or missing, speak to the service
center.
1. Open the package.
2. Read the documentation in the box.
3. Remove all the unassembled parts from the box.
4. Remove the machine from the box.
5. Discard the box and package in compliance with local
regulations.
8.2

ATTACH THE EDGE GUIDE

Figure 2.
The edge guide can limit the cutting range of the machine
and decrease the risk of the damage caused by the rotating
cutting line.
1. Push the edge guide onto the trimmer head until it
engages in the slots.
2. The edge guide can be flipped up for storage.
8.3

ATTACH THE GUARD

Figure 3.
WARNING
Do not touch the cut-off blade.
1. Remove the screws from the trimmer head with a Phillips
head screwdriver (not included).
2. Put the guard onto the trimmer head.
3. Align the screw holes on the guard with the screw holes
on the trimmer head.
4. Tighten the screws.
8.4 ATTACH THE AUXILIARY
HANDLE
Figure 4.
1. Remove the knob from the handle.
2. Attach the auxiliary handle on the shaft.
3. Set the auxiliary handle in the comfortable position.
4. Put the bolt through the holes.
5. Tighten the auxiliary handle with the knob.
8.5

INSTALL THE BATTERY PACK

Figure 5.
NOTE
English
• If the battery pack or charger is damaged, replace the
battery pack or the charger.
• Stop the machine and wait until the motor stops before
you install or remove the battery pack.
• Read, know, and do the instructions in the battery and
charger manual.
1. Align the lift ribs on the battery pack with the grooves in
the battery compartment.
2. Push the battery pack into the battery compartment until
the battery pack locks into place.
3. When you hear a click, the battery pack is installed.
8.6

REMOVE THE BATTERY PACK

Figure 5.
1. Push and hold the battery release button.
2. Remove the battery pack from the machine.
9

OPERATION

Before you operate the machine, read and understand the
safety regulations and the operation instructions.
Be careful when you operate the machine.
9.1

START THE MACHINE

Figure 6.
1. Push the lock-out button and pull the trigger.
9.2

STOP THE MACHINE

Figure 6.
1. Release the trigger to stop the machine.
9.3 ADJUST THE LENGTH OF THE
SHAFT
Figure 7.
You can adjust the length of the shaft to operate the
machine easily.
1. Stop the machine.
2. Push the lock button and move the lower shaft to the
desired position.
3. Release the lock button.
7
WARNING
IMPORTANT
WARNING
NOTE
EN