Ii-5. Wps Setup; Ii-6. Reset To Factory Default Settings - Edimax BR-6476AC User Manual

II-5. WPS Setup
If your wireless device supports WPS (Wi-Fi Protected Setup) then you can use this
method to connect to the BR-6476AC's Wi-Fi network.
1.
Press the WPS button on the BR-6476AC
for 1 – 3 seconds to activate WPS. The
WPS LED will flash for two minutes to
indicate that WPS is active.
2.
Within two minutes, press the WPS
button on the wireless device/client to
activate its WPS.
3.
The devices will establish a connection.
Repeat for additional wireless devices.
Please check the instructions for your wireless device for how long
you need to hold down its WPS button to activate WPS.
II-6. Reset to Factory Default Settings
If you experience problems with your BR-6476AC, you can reset the device
back to its factory settings. This resets all settings back to default.
1.
Press and hold the WPS/Reset button found on the back panel for at least
10 seconds, until the LED begins to light out.
2.
Release the button when the all LED are off.
3.
Wait for the BR-6476AC to restart. The BR-6476AC is ready for setup when
the LED displays on.
20