LoadLifter 5000 Series
4. Attach the axle strap (F) to both lower bracket carriage bolts using two flat washers
INSTALLING THE EMERGENCY BRAKE LINE BRACKET
AND CLIP (DRIVER'S SIDE ONLY)
1. Attach the brake line bracket (Q) to the lower bracket using the previously installed
2. Attach the brake line clip (N) onto the emergency brake line bracket (Fig. 1 & 10).
3. Attach the clip assembly to the brake line bracket using a 5/16" bolt (O), two flat
4. Align the brake line bracket and clip assembly so that the two do not bind to the
Be sure the cable does not rub against the air spring when it is fully inf lated. If it does,
NOTE
adjust the assembly accordingly.
MN-1047
(J) and two nylon lock nuts (L). Torque evenly to 16 lb.-ft. (22Nm) (Fig. 9).
Axle strap (F)
Flat washer (J)
Nylon lock nut (L)
5/16" bolt (O) with one flat washer (J) and a nylon lock nut (M) (Fig. 1 & 10).
washers (J), and a nylon lock nut (M) (Fig. 1 & 10).
cable. Tighten all mounting hardware in this assembly securely.
fig. 9
Brake line clip (N)
5/16" Bolt (O)
5/16" Flat washer (J)
Brake line
Nylon lock nut (M)
Brake line
bracket (Q)
fig. 10
9