Control Functions - Tractor - Briggs & Stratton SnapperPRO S800X Series Operator's Manual

Features and Controls
Features and Controls
Tractor
See Instrument
Control Panel
Control Functions
The information below briefly describes the function of individual controls. Starting, stopping, driving, and mowing require
the combined use of several controls applied in specific sequences. To learn what combination and sequence of controls to
use for various tasks see the OPERATION section.
Cutting Height Adjustment Pin
With the actuator fully extended move the cutting height
adjustment pin to the desired cutting height. Retract the
actuator until it makes contact with the cutting height
adjustment pin to set the cutting height.
Ground Speed Control Levers
These levers control the ground speed of the rider. The
left lever controls the left drive wheel and the right lever
controls the right drive wheel.
Moving a lever forward increases the FORWARD speed
of the associated wheel, and pulling back on and lever
increases the REVERSE speed.
Note: The further a lever is moved away from the neutral
position the faster the drive wheel will turn.
See Zero-Turn Driving Practice section for steering
instructions.
14
A. Serial Number 2014648787 & Below
B. Serial Number 2014648788 & Above
B
Seat Adjustment Lever
The seat can be adjusted forward and back.
Serial Number 2014648787 & Below: Move the lever
away from the seat, position the seat as desired, and
release the lever to lock the seat in position.
Serial Number 2014648788 & Above: Move the lever to
the left, position the seat as desired, and release the lever
to lock the seat in position.
Operating Position Indicator Lamp
The operating position indicator lamp will flash when the
mower deck is not properly positioned in the operating
position. When the mower deck is properly positioned the
operating position indicator lamp will stop flashing and
shut off. See Positioning the Mower Deck for Operation
for instructions on properly positioning the mower deck.
A
www.SnapperPro.com