Advertisement
5
Digital Multiparameter Meter
5.0 Introduction
The Palintest Micro 800 Multiparameter Meter
is part of a range of microprocessor-based
electrochemical instruments designed for hand-
held or benchtop operation. It features a large
dual display LCD with backlit mode for clear and
easy reading. It can store up to 500 data sets
and supports both USB and RS232 output.
The meter has intuitive user-friendly functions
for ease of use and encompasses a durable
waterproof and dustproof IP67 rated design.
Your meter includes a double-junction pH probe,
Conductivity probe, batteries and calibration
solution for your convenience.
Please read this chapter thoroughly before
operating your meter.
5.1 pH Measurement
Getting Started/Connections
After installing (2) AA batteries and/or connecting
the optional 110/220 VAC power supply, connect
the desired sensors to the corresponding ports.
ATC/Con: 6-Pin ATC
or ATC/Conductivity
RS232 - PC or Printer
A/C Power
Adapter
12mm and 16mm probes can
utilise the probe holder to
attach one or more sensors to
a beaker and to the instrument
as needed. The stand can be
extended as shown above or
used for wall-mounting.
34
BNC: pH, mV/ORP
or Ion Selective
Output (USB or
Communication)
Keypad Functions
Press once to power ON in the mode that was
previously used. Press again to turn backlight on for
one minute or off. Hold for 3 seconds to power OFF.
Toggle between measurement and calibration modes.
In SETUP mode, BACK serves to return to the previous
menu option or setting.
Confirm calibration values in CAL mode.
Confirm selections in SETUP mode.
Freeze or release the measured reading.
Customise instrument settings and preferences.
(See also Setup Programs).
Toggle between available measurement types.
Save measurement into memory. Increase value
or scroll up in SETUP or manual calibration.
Recall saved values from memory. Decrease value
or scroll down in SETUP or manual calibration.
Send output data to printer or computer.
Advertisement
