Table of Contents
Advertisement
REPLACING THE LAMP
WARNING! Risk of electric shock.
The lamp can be hot.
1. Turn off the oven.
Wait until the oven is cooled down.
2. Disconnect the oven from the mains.
3. Put a cloth on the bottom of the cavity.
The back lamp
The lamp glass cover is at the back of
the cavity.
TROUBLESHOOTING
WARNING! Refer to Safety chapters.
WHAT TO DO IF...
Problem
You cannot activate the appli-
ance.
You cannot activate the appli-
ance.
The burners do not work.
There is no spark when you try
to activate the spark generator.
The flame extinguishes immedi-
ately after ignition.
The flame ring is uneven.
The oven does not heat up.
The oven does not heat up.
The oven does not heat up.
The lamp does not operate.
The display shows "12.00".
1. Turn the lamp glass cover counterclockwise to
remove it.
2. Clean the glass cover.
3. Replace the oven lamp with a suitable 300 °C
heat-resistant oven lamp.
Use the same oven lamp type.
4. Install the glass cover.
Possible cause
The appliance is not connec-
ted to an electrical supply or it
is connected incorrectly.
The fuse is blown.
There is no gas supply.
Burner cap and crown are
placed incorrectly.
Thermocouple is not heated up
sufficiently.
Burner crown is blocked with
food residues.
The oven is deactivated.
The clock is not set.
The necessary settings are not
set.
The lamp is defective.
There was a power cut.
Remedy
Check if the appliance is cor-
rectly connected to the electri-
cal supply.
Make sure that the fuse is the
cause of the malfunction. If the
fuse is blown again and again,
contact a qualified electrician.
Check the gas connection.
Place the burner cap and
crown correctly.
After lightning the flame, keep
the knob pushed for equal or
less than 10 seconds.
Make sure that the injector is
not blocked and the burner
crown is clean.
Activate the oven.
Set the clock.
Make sure that the settings are
correct.
Replace the lamp.
Reset the clock.
21
Advertisement
Table of Contents
