Table of Contents
Advertisement
BEFORE FIRST USE
WARNING! Refer to Safety chapters.
INITIAL CLEANING
Remove all accessories and removable shelf
supports from the oven.
Refer to "Care and cleaning" chapter.
Clean the oven and the accessories before the first
use.
Put the accessories and the removable shelf
supports back to their initial position.
SETTING AND CHANGING THE TIME
You must set the time before you operate the oven.
When you connect the appliance to the electrical
supply or after a power cut,
Press the
or
to set the correct time.
HOB - DAILY USE
WARNING! Refer to Safety chapters.
IGNITION OF THE HOB BURNERS
Always light the burner before you put
on the cookware.
WARNING! Be very careful when you
use open fire in the kitchen
environment. The manufacturer
declines any responsibility in case of
the flame misuse.
1. Turn the knob for the hob to the position
and push it down. When you push the knob,
the spark generator activates automatically.
2. Keep the knob for the hob pushed for equal or
less than 10 seconds to let the thermocouple
warm up. If not, the gas supply is interrupted.
3. Adjust the flame after it is regular.
WARNING! Do not keep the knob
pushed for more than 10 seconds. If
the burner does not light after 10
seconds, release the knob, turn it into
the off position and try to light the
burner again after minimum 1 minute.
8
flashes.
After approximately 5 seconds, the flashing stops
and the display shows the time of day.
To change the time, press
starts to flash.
PREHEATING
Preheat the empty appliance before first use.
Preheat the two ovens. Heat up one
oven at a time.
1. Set the maximum temperature.
2. Let the appliance operate for 1 hour.
3. Set the function
4. Let the appliance operate for 15 minutes.
Accessories can become hotter than usual. The
appliance can emit an odour and smoke. This is
normal. Make sure that the airflow is sufficient.
If after some tries the burner does not
light, check if the crown and its cap
are in the correct position.
In the absence of electricity you can
ignite the burner without an electrical
device. In this case approach the
burner with a flame, push the relevant
knob down and turn it to maximum
position. Keep the knob pushed for
equal or less than 10 seconds to let
the thermocouple warm up.
If the burner accidentally goes out,
turn the knob to the off position and try
to light the burner again after minimum
1 minute.
The spark generator can start
automatically when you switch on the
mains, after installation or a power cut.
It is normal.
again and again until
.
Advertisement
Table of Contents
