Main Oven Functions - Zanussi ZCG63250BA User Manual

Oven function
Heat settings
1)
1 - 8
Ignition
1) 1 - 155 °C, 2 - 170°C, 3 - 185°C, 4 -200°C, 5 - 220°C, 6 - 250°C, 7 - 275°C, 8 - 295°C

MAIN OVEN FUNCTIONS

Oven function
Off position
Minimum temperature
Heat settings
1)
1 - 8
Ignition
1) min - 130 °C, 1 - 155°C, 2 - 170°C, 3 -185°C, 4 - 205°C, 5 - 225°C, 6 - 240°C, 7 - 255°C, 8 -
260°C
IGNITING THE OVEN BURNERS
CAUTION! When the oven is active,
the lid has to be opened to avoid over-
heating.
Keep the oven door open when you
ignite the burner.
Oven safety device:
The oven burners have a
thermocouple. It stops the gas flow, if
the flame goes out.
You cannot operate the top oven
burner, when the grill is active.
1. Open the oven door.
2. Push the knob for the main oven and turn it
counterclockwise to
burner.
• Push the knob for the top oven and turn it
counterclockwise to
oven burner.
3. Keep the knob pushed for equal or less than
15 seconds to let the thermocouple warm up. If
not, the gas flow is interrupted.
4. After ignition release the knob, close the oven
door and turn the knob to set the necessary
heat setting.
Heat settings for Conventional Cooking.
To activate the top oven.
The oven is off.
To set the minimum temperature.
Heat settings for Conventional Cooking.
To activate the main oven.
to ignite the main oven
to ignite the top
Application
Application
WARNING! Do not push the knob for
more than 15 seconds. If the oven
burner does not light after 15
seconds, release the knob, turn it back
to off position and try to light the oven
burner again after minimum 1 minute.
CAUTION! In the absence of
electricity you can ignite the oven
burner without an electrical device. In
this case open the oven door, put the
flame near the hole in the bottom of
the oven cavity, turn the knob to the
spark position and push it down. Keep
the knob for the oven functions
pushed for equal or less than 15
seconds to let the thermocouple warm
up.
If the oven burner accidentally goes
out, turn the knob for the oven
functions to the off position and try to
light the burner again after minimum 1
minute.
Check if the burner holes are not
blocked.
11