Scheduled Maintenance; Machine Troubleshooting - CleanFreak 225BUCF Operator's Manual

Check for loose or lost fasteners
Inspect cords and connections
Inspect pad holder for damage
Clean the machine and accessories
Check machine wiring for fray or cut
Check the carbon brushes of motor
These items must be performed with the proper tools and training. Contact an Amano
Pioneer Eclipse Factory Certified Technician unless you have the proper equipment and
technical proficiency.
Problem
No power
Machine will not start
Switch lever safety lock not depressed
Bad connection
Defective motor start switch
Low voltage
Motor runs sluggish Bad motor run capacitor
Handle is not locked
Defective handle switch
Low voltage
Not on a dedicated circuit
Fuse / circuit breaker
Motor is overloaded
repeatedly trips
Bad connection
Handle is not locked
Defective motor
Defective pad
Machine vibrates during
Warped or damaged padholder
operation
Pad not installed properly / not centered
There are lines on the floor
Poor Performance
There floor does not shine

Scheduled Maintenance

Operation

Machine Troubleshooting

Possible Cause
Daily
l
l
l
l
Check the main power supply (building circuit breaker).
Check the cord connection at the wall outlet
Hold in the switch lever safety lock and then engage switch levers.
Check the motor and cord interlock connections.
Contact CleanFreak.com
Contact an authorized APEC Distributor.
Using extension cord with wire smaller than 12/3. Replace with a 12/3 extension cord.
Using more than one extension cord. Only use one 50ft 12/3 extension cord.
Contact CleanFreak.com
Contact an authorized APEC Distributor.
Push down on handle release lever to lock handle.
Contact CleanFreak.com
Contact an authorized APEC Distributor.
Eliminate extension cord & locate a power source closer to work site.
Have voltage checked by a qualified electrican.
Make sure there is no other items using power on the circuit.
Try a different pad that is less aggressive.
DO NOT add weight to machine. Remove any excess weight added to machine.
Contact CleanFreak.com Contact an authorized APEC Distributor.
Push down on handle release lever to lock handle.
Contact CleanFreak.com
Contact an authorized APEC Distributor.
One side is more dense than the other. Replace pad.
Replace.
Remove and install properly.
The floor was not cleaned before buffing. Scrub and clean the floor.
Clean the pad or replace with a new clean pad.
Use the appropriate pad for the job.
11
Interval
Every 6
Monthly
Months
l
Solution
l