Operation; After Use - CleanFreak 225BUCF Operator's Manual

Operation

1. Unwrap the power cord and plug it into the properly
grounded outlet.
2. Pull up on the handle release lever (5). Move the
operator handle (4) downward until your arms are
almost straight. Push down on the handle release
lever (5) to lock it in place.
3. Lift up on the operator handle (4) until the driver is
flat against the floor.
WARNING! Be prepared to control the machine as
soon as the motor starts.
CAUTION! Immediately start moving the machine
back and forth. Keep the machine moving while the
motor is running to avoid damage to the floor.
4. Hold one of the operator handle grips (1) firmly, push
the switch lever safety lock (2) and the compress the
switch lever (3) to start the motor.
Note: When the switch levers (3) are released, the
machine shuts off immediately.
4
2
5
Figure 7
1. Place the operators handle (4) in the upright (vertical)
position and unplug the power cord. Wrap the power
cord around the operator hand grips (1) and the cord
hook (6).
2. Tilt the machine back and remove the pad driver from
the machine. NEVER store the machine with the pad
driver on the machine.
3. Wipe the entire machine with a clean, damp cloth.
4. Inspect the entire machine and all accessories for
damage. Perform any required maintenance or
repairs before storage.
5. Store the machine in a clean, dry place with the
operator handle (4) locked in the upright position.
1
3
6
10

After Use