Troubleshooting - Emeril Lagasse Pressure Air Fryer Plus Y6D-AF-36B Owner's Manual

Troubleshooting

Symptom Possible Cause
Cannot open Pressure
Lid
Pressure Lid does not Inner Lid Rubber Gasket is not properly
lock installed
Cannot open Pressure
Float Valve and Pressure Release Valve
Lid after pressure is
are still raised
released
Pressure Lid incorrectly installed
Inner Lid not installed
Air escapes from the
rim of the Pressure Lid
Inner Lid Rubber Gasket not installed or
and pressure will not
incorrectly installed
increase
Food residue on Inner Lid Rubber Gasket
Inner Lid Rubber Gasket is damaged
or worn out
Food stuck on Float Valve Rubber Gasket
Air escapes from Float
Valve during operation
Inner Lid not installed
Float Valve Rubber Gasket is worn out
Appliance is not filled with enough food
or water
Float Valve does
not rise
Air is escaping from rim of Lid and/or
from Pressure Release Valve
Float Valve not assembled correctly
Liquid spitting out of
Too much liquid in Unit
Float Valve
Unit turns off
Appliance is overheated
unexpectedly
32
6- & 8-Quart Emeril Lagasse Pressure AirFryer™ Plus
Solution
DO NOT FORCE OPEN.
Reinstall Inner Lid Rubber Gasket.
Ensure the Pressure Release Valve is open, the Steam Release Switch
is in the Open position, and you have let go of the Steam Release Switch.
CAUTION: Hot steam may be released during this process. DO NOT
FORCE THE UNIT OPEN. Do not place face, hands, or body near valve
opening.
See ATTACHING LID in INSTRUCTIONS FOR PRESSURE COOKING,
p. 20.
Install Inner Lid (see INNER LID ASSEMBLY in INSTRUCTIONS FOR
PRESSURE LID ASSEMBLY, p. 16).
Install Inner Lid Rubber Gasket.
Clean Inner Lid Rubber Gasket.
Replace Inner Lid Rubber Gasket. Contact Customer Service (see the
back of the manual for contact information). for replacement parts.
Clean Float Valve Rubber Gasket.
Install Inner Lid.
Replace Float Valve Rubber Gasket. Contact Customer Service
for assistance (see the back of the manual for contact information).
Check recipe for proper quantities of solids and liquids.
Contact Customer Service for assistance (see the back of the manual
for contact information).
Float Valve should be able to move up and down, stopping only when
its Rubber Gasket meets the Lid interior. Ensure that its Rubber Gasket
is clean and the Float Valve can move freely.*
Allow the cooking cycle to finish. Clean the Float Valve thoroughly. Use
less liquid in future recipes.
Unplug and let the Unit cool for 30 mins. in order to reset.
CONTINUED ON NEXT PAGE