Confer Plastics STEP-1 Assembly And Installation Manual page 4

Safety Information
1) Always follow the manufacturer's recommendations for
the safe use of all hand tools and equipment.
2). Do not use the Confer-Step for any purpose other than
that for which it is intended.
3). When lifting awkward or heavy loads, have another
person help you.
4). Maximum weight on steps not to exceed
5). Exceeding the recommended weight
WARNING:
restriction may cause the unit to fail.
6). Consult your local building department before
installation of your pool and equipment.
Confer Plastics, Inc. warrants their swimming pool ladders to be free from defects in workmanship for one year from
date of purchase. After the first year the cost to replace a part is as follows:
STEP-1
2 nd Year - 20%
3 rd Year - 40%
4 Year - 60%
th
5 th Year - 80%
Plus shipping/handling
Enclose proof-of-purchase (receipts, etc.) showing date purchased, your name, address, and daytime phone number. You
will be notified of cost to replace part.
This warranty gives you specific legal rights, and you may also have other rights which may vary from state to state.
MADE IN THE U.S.A. by:
Printed in U.S.A.
4
400 lbs.
Options available – To make an
up-and-over step system with gate
as shown for your pool purchase
our #Step-Enc Enclosure Kit and
an additional #Step-1.
Contact your dealer or check
online at
www.conferladders.com
CONFER PLASTICS, INC.
LIMITED, PRO-RATED WARRANTY
DO NOT RETURN DEFECTIVE PART TO DEALER
of current parts
The defective part should be returned, postpaid, to:
list price
TO WINTERIZE YOUR POOL
We suggest removing your Confer-Step from the pool for the off-
season months.
If your Confer-Step is attached to a deck: Two people are required
for this operation and it is best to remove the unit while the water is
still warm enough so that one person can get into the pool.
Disconnect the mounting brackets from the deck. The person in the
water can lift the unit up while the person on the deck helps to pull
and guide the unit onto the deck. After the unit is on the deck, and
the water has drained out of the steps, lay the unit on it's back side
so that most of the water drains from the side panels.
If getting into the water is not an option the unit can be removed by
both people standing on the deck and lifting and tilting the unit to
drain some of the water from the steps. After the unit is light enough
carefully lift it from the pool. Caution: Use care when lifting the unit.
It will weigh at least 130 lbs.
If you have the Confer-Step Enclosure System or Connector
System: disconnect the two units by removing the center
platform/side rail assembly at the top of the steps. Do not stand on
the top step of the outside unit as it may tip. Lift up the unit inside
the pool and tilt it so that water drains out of the steps. Once it is
light enough carefully lift it over the side of the pool, lay the unit on
it's back side and allow most of the water to drain from the side
panels.
The Confer-Step can be covered, if desired, and stored outdoors.
Confer Plastics, Inc.
97 Witmer Road
North Tonawanda, N.Y. 14120-2421
97 Witmer Road
North Tonawanda, New York 14120-2421
Toll Free U.S. 866-396-2968
716-283-1826/ FAX 716-283-3249
www.conferladders.com
CP-STEP-1-US 01-08