Replacing The Presser Foot - Janome CoverPro 3000 Instruction Book

q
w
e
q
w
e
7

Replacing the Presser Foot

CAUTION:
Turn off the power switch when changing the presser
foot.
Removing the Presser Foot
Turn off the power switch.
Turn the handwheel toward you to raise the needle to its
highest position.
Raise the presser foot lifter.
Press the lever located on the back of the foot holder.
The presser foot will drop off.
q Handwheel
w Lever
e Foot holder
CAUTION:
Do not push the lever from the top.
Attaching the Presser Foot
Turn off the power switch.
Place the presser foot while lifting the presser foot lifter to
the extra lifted position, so that the pin on the foot lies just
under the groove of the foot holder (refer to page 6).
Lower the foot holder to lock the foot into place.
Raise the presser foot lifter to check that the presser foot
is secure.
q Foot holder
w Groove
e Pin