Humidifying Tray - Sharp EH-HS41 Manual

HUMIDIFYING TRAY

Care Cycle 1 month
1
Remove the Water Tank and Humidifying
Tray.
Unlatch the Water
Tank first, then re-
move the tray. Use
b o t h h a n d s w h e n
pulling out the Hu-
m i d i f y i n g Tr a y t o
avoid spilling water.
2
Remove the Humidifying Filter from the
Humidifying Tray. Drain accumulated wa-
ter by tilting the Humidifying Tray slowly.
Humidifying Filter
3
Rinse the inside of the Humidifying
Tray with lukewarm water to remove
impurities.
• Do not remove the Styrofoam float.
• Clean difficult-to-reach parts with a cotton-
tipped swab or tooth brush.
If the Styrofoam float comes off,
replace by inserting the tabs of
the Float into the holes in the
Humidifying Tray as shown in the
diagram.
KC-930TA.indd 31
Frequency of maintenance cycle will depend on the hardness
of the water. Avoid spilling water when removing or cleaning
the tray.
Humidifying Tray
Insert the tab of the
float into the hole.
E-11
When Water Deposits are Difficult to Remove
1
Fill Humidifying Tray half-
way with lukewarm water,
add a small amount of mild
kitchen detergent, and leave
to soak for about 30 min-
utes.
Dilute detergent according to
instructions on the container.
Clean difficult-to-reach parts
with a cotton swab or tooth
brush.
2
Rinse the Humidifying
Tray with lukewarm wa-
ter.
• Rinse until all detergent residue
is removed.
• Inadequate rinsing may cause
the detergent odour or changes
in the shape/colour of the main
unit.
CAUTION
• Use only mild kitchen detergents to
clean the Humidifying Tray. Use of
non-designated chemicals or deter-
gents can cause deformation, tar-
nishing, cracking (water leakage).
Insert the float below
this tab.
I n s e r t t h e t a b o n
the other side of the
float into the hole.
09.9.30 2:23:00 PM