Recommended Combustion Air Inlet Moisture Trap; Combustion Air; Vent Pipe Diameter Transition Location And Elbow Configuration - Payne PG95ESA Installation, Start-Up, Operating And Service And Maintenance Instructions

A
A
A
TO CODE- - APPROVED DRAIN OR CONDENSATE PUMP
Recommend "T" fitting with 4--inch minimum height standpipe (A) of same diameter or larger extending upward.
Tee
Tee
Dry Well
Tee
Dry Well
Cap
(water tight
Dry Well
and removable)
Cap
Cap
(water tight
(water tight
and removable)
and removable)
Representative drawing only, some models may vary in appearance.
A170122A
Fig. 39 - - Recommended Combustion Air Inlet Moisture Trap
FURNACE
NOT IN
HORIZONTAL
SECTION
PIPE DIAMETER
TRANSITION IN
VERTICAL SECTION
A93034
Fig. 40 - - Combustion Air and Vent Pipe Diameter Transition Location and Elbow Configuration
42