Important Safety Instructions - Star Trac CORE HEALTH & FITNESS Owner's Manual

IMPORTANT SAFETY INSTRUCTIONS

Before using this product, it is essential to read the ENTIRE Owner's Manual and ALL
installation instructions. The Owner's Manual describes equipment assembly and instructs
members on how to use correctly and safely.
Read all warnings posted on the machine.
Health related injuries may result from incorrect or excessive use of exercise equipment.
Core Health & Fitness strongly recommends you to encourage your members to discuss their
health program or fitness regimen with a health care professional, especially if you or they
have not exercised for several years, are over 35, or have known health conditions.
DANGER: to reduce the risk of electrical shock:
1. Always unplug the machine from the electrical
outlet before cleaning or servicing.
2. This machine is not intended to be serviced by
the end user, refer servicing to qualified personnel
only.
3. This product is factory-equipped with a specific
DC Power Supply to permit connection to the
proper electric circuit. Make sure that the product
is connected to a dedicated power line having
an outlet with the same configuration as that of
the plug. If the power supply cord is damaged, it
must be replaced by the manufacturer, its service
agent, or similarly qualified persons in order to
avoid hazard.
4. Improper connection of the equipment-grounding
conductor can result in a risk of electric shock.
Check with a qualified electrician or serviceman
if you are in doubt as to whether the product
is properly grounded. Do not modify the plug
provided with the product. NO adapter should
be used with this product. If the product must
be reconnected for use on a different type of
electric circuit, the reconnection should be made
by qualified service personnel in order to avoid a
hazard.
5. Keep power cord away from heated surfaces.
Unplug power cord when the machine is
unattended and before performing any
preventative maintenance such as cleaning or
replacing a worn part.
6. Do not operate machine in damp or wet locations
Page 2
WARNING!
WARNING: to reduce the risk of serious injury to
persons using this equipment, read and follow all of
these warnings:
1. Assemble and operate the machine on a solid
level surface. Position the machine with a
minimum of 24 inches (0.6 meters) of clearance
on at least one side to allow for ease of mounting
and dismounting. Allow for 24 inches (0.6
meters) of clearance behind the machine. These
dimensions are the recommended minimum
distances.
The actual area for access and passage shall be
the responsibility of the facility and should take
into account this training envelope, Americans
with Disabilities Act Accessibility Guidelines
(ADAAG) requirements and any required local
codes or regulations (www.access-board.gov/
ada).
24 in (0.6 m)
Required Clearance
Fig. 1