AEG CIS6741ECM User Manual page 33

Problem
An acoustic signal sounds
and the hob deactivates.
An acoustic signal sounds
when the hob is deactivated.
Residual heat indicator does
not come on.
Automatic Heat Up function
does not operate.
Automatic Heat Up function
does not operate.
The sensor fields become
hot.
There is no signal when you
touch the panel sensor
fields.
comes on the hob dis-
play.
comes on the hob dis-
play.
comes on the hob dis-
play.
comes on the hob dis-
play.
comes on the hob dis-
play.
The oven does not heat up.
The oven does not heat up.
The oven does not heat up.
The lamp does not operate.
The display shows "12.00".
Possible cause
You put something on one
or more sensor fields.
The zone is not hot because
it operated only for a short
time.
The zone is hot.
The highest heat setting is
set.
The cookware is too large or
you put it too near to the
controls.
The signals are deactivated.
Automatic Switch Off oper-
ates.
The Child Safety Device or
the Lock function operates.
There is no cookware on the
zone.
The cookware is incorrect.
The diameter of the bottom
of the cookware is too small
for the zone.
The oven is deactivated.
The clock is not set.
The necessary settings are
not set.
The lamp is defective.
There was a power cut.
ENGLISH
Remedy
Remove the object from the
sensor fields.
If the zone operated suffi-
ciently long to be hot, speak
to an Authorised Service
Centre.
Let the zone become suffi-
ciently cool.
The highest heat setting has
the same power as the func-
tion.
Put large cookware on the
rear zones if possible.
Activate the signals. Refer to
"Hob - Daily use" chapter.
Deactivate the hob and acti-
vate it again.
Refer to "Hob - Daily use"
chapter.
Put cookware on the zone.
Use the correct cookware.
Refer to "Hob - Hints and
tips" chapter.
Use cookware with correct
dimensions. Refer to "Hob -
Hints and tips" chapter.
Activate the oven.
Set the clock.
Make sure that the settings
are correct.
Replace the lamp.
Reset the clock.
33