www.aeroplusrc.com
Assemble the rudder servo control arm as below, drill holes for screws and use CA
glue to stop the nuts from coming loose.
Fit the rudder servo and drill holes using a fine drill for the servo screws, drop thin CA
glue into the holes to strengthen the wood.
Using servo screws fix the servo in place, note the spline is towards the front of the
plane
The closed loop wires are assembled in the plane; attach the rear ball joints to the
rudder. Do this to both sides.
AeroPlus RC Copyright 2013 © All Rights Reserved
service@aeroplusrc.com