Advertisement
www.aeroplusrc.com
Aileron Servos
The ailerons on the wings are pre-glued. Check each one by gently pulling to make
sure that they are secure
Remove the covering where the aileron horns are glued in place. Use either a
soldering iron or a sharp knife
Using sand paper rough the area that will be glued into the aileron.
Glue both horns in with epoxy glue, use a bolt through the horns when gluing to
make sure the alignment is correct.
AeroPlus RC Copyright 2013 © All Rights Reserved
service@aeroplusrc.com
Advertisement
