Advertisement
www.aeroplusrc.com
Re-fit the elevator servo and secure it in with servo screws after the glue fully dries.
Centre the servo using your TX, and fit a servo arm. Use either an aftermarket arm or
attach the arms that were supplied to a servo head. Screw ball joints onto the
pushrod (use pliers to hold pushrod) and bolt in place with supplied bolts. Centre of
servo should align with elevator flat to the stab.
Rudder
Remove the covering where the rudder horns push through with either a knife or
soldering iron.
AeroPlus RC Copyright 2013 © All Rights Reserved
service@aeroplusrc.com
Advertisement
