Uniden XDECT SSE47 Series Owner's Manual page 9

Set Up the Accessory Handset(s)
Install and Charge the battery
1. Unpack all handsets, battery packs, and battery
covers. If you need to remove a cover, press in on
the notch and slide the cover down and off.
2. Line up the battery connector with the jack inside
the handset; the connector only fits one way.
3. Push the connector in until it clicks into place; tug
gently on the wires to make sure the battery is
securely connected.
4. Replace the battery cover and slide it into place.
5. Use an AC adaptor to connect the power jack on the base to a regular indoor
(240V AC) power outlet.
6. Place each handset in the base with the display facing forward. If the battery icon
does not begin cycling through levels, reset the handset or connect the base to a
different outlet.
# Charge all handsets completely (about 15 hours) before using.
Test the Connection
7. Pick up each handset and press TALK/FLASH. You should hear a dial tone, and the
display should show Talk. (Press TALK/FLASH or END/CLEAR again to hang up.)
8. If there is noise or static, refer the section, 'There's a lot of noise or static on the line'
on page 37 for tips on avoiding interference.
Using the Belt Clip
To attach the belt clip
1. Line up the holes on each side of the handset.
2. Insert the belt clip into the holes on each side of the handset.
3. Press down until it clicks.
To remove the belt clip
Pull either side of the belt clip to release the tabs from the holes.
9