Incorrect Date And Time; System Will Not Boot; Hdd Error Messages At System Boot - Fujitsu PRIMERGY RX2520 M4 Operating Manual

Troubleshooting and tips
8.6

Incorrect date and time

Ê Set the date and time in the operating system or in the BIOS Setup under
the Main menu, using System Date and System Time respectively.
I
Note that the operating system may affect the system time. For example,
the operating system time may deviate from the system time under
Linux, and would overwrite the system time in the default setting on
shutdown.
If the date and time are still wrong after the server has been switched off and
back on again, replace the lithium battery (for a description refer to the
"FUJITSU Server PRIMERGY RX2520 M4 Upgrade and Maintenance
Manual") or contact our customer service team.
8.7

System will not boot

The system will not boot after installing a new hard disk drive.
SAS configuration incorrect
Ê Check the settings for the hard disk drives (SAS Device Configuration) and
the additional settings in the SAS configuration menu.
8.8

HDD error messages at system boot

Various HDD error messages may occur when the system is rebooted. These
error messages are caused by modifications in the selected RAID configuration.
RAID controller configuration incorrect
Ê Check and correct the settings for the drives using the RAID controller
configuration program.
I
Further information is provided in the "Integrated RAID for SAS User's
Guide" (on the Fujitsu manuals server under x86 Servers - Expansion Cards
- Storage Adapters - LSI RAID / SCSI Controllers) or in the "Modular RAID
Controller Installation Guide" (on the Fujitsu manuals server under x86
Servers - Expansion Cards - Storage Adapters - LSI RAID / SCSI Controllers).
For more information on configuring the controller, see section
"Configuring the server" on page
90
80.
Operating Manual
RX2520 M4