Power Management; Batch Mode; General Operation - HID Technology Solutions 1062 Manual

Using the 1062 Handscanners with Motorola WT4000
The device name may have been reprogrammed. If this customisation is no longer wanted then the
'Revert Factory Default' option in the PC based configuration software can be used to restore the
Bluetooth name to the Handscanner serial number as printed on the side of it.
The view in BTExplorer looks different to the examples.
Within BTExplorer use ALT ALT to bring up the application menu bar, scroll to 'View' and then 'Large
Icons'. Press ENTER to confirm.
6.3.
What power saving modes does the Handscanner have?
The Handscanner makes full use of standard Bluetooth power saving modes. This allows the terminal
and Handscanner to reduce the proportion of the time that the link is active when there is no data
being transmitted whilst at the same time operating at full speed whilst there is data to be transmitted.
This is transparent to the user and greatly reduces the current consumption whilst the Handscanner is
connected but idle.
When the Bluetooth link has been disconnected, and if the button is not pressed the Handscanner
automatically powers down after 120 seconds. This duration can be configured.
6.4.
How does Batch Mode work?
When Batch Mode is enabled on the Handscanner the unit automatically stores scan data in internal
non-volatile memory when there is no Bluetooth connection. This data can be read out from memory
on demand over the Bluetooth link or when the Handscanner is docked. The commands to read the
data are documented in the Programmer's Guide and supported in the API. Alternatively the PC
based Configuration Application can be used to download batch data into a file.
How much data can the Handscanner store?
Approximately 4000 barcodes or RFID serial numbers.
How is batch mode enabled?
Batch mode is enabled by command as documented in the Programmer's Guide. Alternatively the PC
based Configuration Application can be used to enable batch mode.
6.5.
Can the Handscanner only be triggered by the yellow button?
It is possible to fully control the operation of the Handscanner (trigger, audible alert, vibration alert) by
sending standard commands from an application on the terminal. These commands are documented
in the Programmer's Guide.
Technology Solutions (UK) Limited reserves the right to change its products, specifications and services at any time without notice. Technology Solutions (UK) Limited
provides customer assistance in various technical areas, but does not have full access to data concerning the uses and applications of any customer's products.
Therefore, Technology Solutions (UK) Limited assumes no responsibility for customer product design or for infringement of patents and/or the rights of third parties, which
may result from assistance provided by Technology Solutions (UK) Limited. No part of this document may be reproduced in any form without the written consent of the
author.
www.tsl.com

Power Management

Batch Mode

General operation

Page 16 of 22
Using the 1062 Handscanners with Motorola WT4000.pdf
1062