Connecting To The Handscanner; Disconnecting From The Handscanner - HID Technology Solutions 1062 Manual

Using the 1062 Handscanners with Motorola WT4000
Use TAB again to highlight 'OK' and press SPACE to accept the settings. Launch DataWedge again
and scroll to 'Serial' and 'Options':
It is recommended that 'Re-establish on Resume' is selected. This automatically attempts to
reconnect to the Handscanner when the terminal resumes. For this to work reliably the Handscanner
should be powered on before resuming the terminal.
The 'Send data after' options may need to be altered depending on the application. With the default
settings in the Handscanner the barcode or RFID data has CR+LF appended. If 'CR received' or LF
received' are selected then the data is sent immediately it is completely received and the remaining
CR or LF can be used as the data separator in the target application. Alternatively using the default '1
second' option allows both CR and LF to be passed but at the expense of slower response time.
When the settings have been configured use TAB to highlight OK and press SPACE to exit.
Other DataWedge Serial options (Prefix, suffix and feedback) can also be configured at this stage
following the instructions in the user manual.
4.3.
Ensure that the Handscanner is switched on. Launch DataWedge from the Start Menu again. Scroll to
Serial and highlight 'Enable'. Press enter and the connection will be started. The alert will clear from
the DataWedge icon in the taskbar and the blue LED on the Handscanner will light continuously to
show that the link is active.
Scanned barcode and RFID data will be fed to the application with focus with formatting according to
the settings in DataWedge.
4.4.
Launch DataWedge from the Start Menu. Scroll to Serial and highlight 'Disable'. Press ENTER and
after a few seconds the Bluetooth link is closed and the blue LED on the Handscanner reverts to a
slow flash.
The Handscanner automatically powers off after 120 seconds (default) of no button press when the
link is closed.
Technology Solutions (UK) Limited reserves the right to change its products, specifications and services at any time without notice. Technology Solutions (UK) Limited
provides customer assistance in various technical areas, but does not have full access to data concerning the uses and applications of any customer's products.
Therefore, Technology Solutions (UK) Limited assumes no responsibility for customer product design or for infringement of patents and/or the rights of third parties, which
may result from assistance provided by Technology Solutions (UK) Limited. No part of this document may be reproduced in any form without the written consent of the
author.
www.tsl.com

Connecting to the Handscanner

Disconnecting from the Handscanner

Page 8 of 22
Using the 1062 Handscanners with Motorola WT4000.pdf
1062