Radyne DMD2050 FTP Setup Procedure page 6

AN186 - Rev. 1.0
DMD2050 FTP
3. The IP address on the Front Panel is expressed in a hexadecimal format by default.
Enter the DMD2050 Internet Address and press <ENTER>. Please consult your network
administrator for valid addresses.
Example: For the decimal Modem IP Address of 172.18.100.215, enter:
IP Mask = FF.FF.0.0
Modem IP Address = AC.12.64.D7
4. Broadcast and loopback addresses will not be allowed.
5. The IP Address that is selected will be used for the Ethernet Test that follows.
6.5 Server IP Address (Valid only if Boot Mode is set to BootP)
This section refers to the host that will be used to optionally boot the
DMD2050 on power-up, and to the address of the SNMP Trap Server when
SNMP is active. The host should be acceptable to the transport layer. In
other words, the transport layer needs to be able to open a connection to
the entity specified by the Server IP Address field.
This IP Address needs to be consistent with the Modem IP Address. If a
router has been specified, the address is presumed to be reachable via
the router. If the server is also within the same subnet as the modem,
both the router and the server will receive the same IP packets. The router
will relay the packets to a different subnet where they will be ignored.
1. At the <TCP/IP> Submenu, scroll to the 'SERVER IP ADDR' Selection.
2. Toggle between hexadecimal and decimal formats by pressing all four Arrow Keys at the
same time then releasing.
3. The IP Address on the Front Panel is expressed in a hexadecimal format by default.
Enter the Server Internet Address and press <ENTER>. Please consult your network
administrator for valid addresses.
Example: For a no router specified and a Server IP Address of 172.18.4.250, enter:
IP Mask = FF.FF.0.0
Modem IP Address = AC.12.64.D7
Server IP Address = AC.12.4.FA
Router IP Address = A0.0.0.01
4. Broadcast and loopback addresses will not be allowed.
5. The IP Address that is selected will be used for the Ethernet Test that follows.
Page 4