Time Display - Scott SMV100 Owner's Manual

3. Press MEMORY
number flashes to the left of the frequency, for example:
MEMORY CH 02 89. 1 MHz FM. After a few seconds the flashing stops and the
memory number is set.
Note-Instead of using
the remote. In the above example, you would press
Note after pressing
seconds, otherwise the number will not be stored.
Selecting stored radio stations
1. Press BAND to select required band.
2. Press MEMs
Alternatively, you can use the number keys on the remote.
Examples: For memory 7 simply press 7.
For memory 14 press + 10 then 4.
For memory 20 press + 10 twice then 0.
FM mono/stereo
You can set FM radio stations to mono (for example if FM stereo reception is
noisy). To switch between FM mono and stereo, lower the front panel flap
and press FM MONO/STEREO.

Time display

To display the current time, press
Note-pressing
OFF settings. These are explained on the next page.
followed by MEMs
and
MEMs
MEMORY you must enter a memory number within 5
or MEMt to select required memory number.
MODE
repeatedly also displays any TIMER ON and TIMER
MODE
or MEMt
you can use the number keys on
MEMt
MEMORY
once.
19
Radio operation
so that the memory
followed by 2.