FujiFilm instax SHARE SP-3 User Manual page 25

Wireless Network Devices: Cautions
IMPORTANT: Read the following notices before using the printer's built-in wireless transmitter.
■ Use only as part of a wireless network.
FUJIFILM does not accept liability for damages resulting from unauthorized use. Do not use in applications requiring a
high degree of reliability, for example in medical devices or other systems that may directly or indirectly impact human
life. When using the device in computer and other systems that demand a greater degree of reliability than wireless
networks, be sure to take all necessary precautions to ensure safety and prevent malfunction.
■ Use only in the country in which the device was purchased.
This device conforms to regulations governing wireless network devices in the country in which it was purchased.
Observe all location regulations when using the device. FUJIFILM does not accept liability for problems arising from use in
other jurisdictions.
■ Wireless data (images) may be intercepted by third parties.
The security of data transmitted over wireless networks is not guaranteed.
■ Do not use the device in locations subject to magnetic fields, static electricity, or radio interference.
Do not use the transmitter in the vicinity of microwave ovens or in other locations subject to magnetic fields, static
electricity, or radio interference that may prevent reception of wireless signals. Mutual interference may occur when the
transmitter is used in the vicinity of other wireless devices operating in the 2.4 GHz band.
■ The wireless transmitter operates in the 2.4 GHz band using DSSS and OFDM modulation.
■ This device operates on the same frequency as commercial, educational, and medical devices and
wireless transmitters.
It also operates on the same frequency as licensed transmitters and special unlicensed low-voltage transmitters used in
RFID tracking systems for assembly lines and in other similar applications.
■ To prevent interference with the above devices, observe the following precautions.
Confirm that the RFID transmitter is not in operation before using this device. Should you observe that the device causes
interference in licensed transmitters used for RFID tracking, immediately choose a new operating frequency for this device
to prevent additional interference. If you notice that this device causes interference in low-voltage RFID tracing systems,
contact a FUJIFILM representative.
■ Certification marks acquired by the printer are located inside the film chamber
EN
25