FujiFilm instax SHARE SP-3 User Manual page 17

Problems
1 The film pack is not for your printer.
The film pack cannot
be loaded, or cannot be 2 The film pack is not being loaded
loaded smoothly.
The film cover cannot ● The printer cannot recognize the
be ejected.
The film cannot be ● The printer shakes or has been
ejected to the end.
1 The printer shakes or has been
The film pack cannot be
ejected.
2 The film has been jammed.
Possible Causes
correctly.
film pack.
dropped and the film has become
misaligned.
dropped and the film is misaligned.
Solutions
1 Use FUJIFILM Instant Film "instax SQUARE" only.
(No other films can be used.)
2 Match the yellow line on the film pack with the
yellow positioning mark in your printer.
● Remove the film pack and load it again.
1 Grasp the edge of the film and pull it out.
2 Performing another printing operation pushes
the jammed film out.
1 Load a new film pack.
2 Remove the battery and insert it again. If this does
not solve the problem, remove the jammed film
and load a new film pack.
EN
17