Helmholz 700-841-16S01 Instruction Manual

Ethernet Switch 16-port, unmanaged, 10/100/1000 Mbps
700-841-16S01
Version 2 for HW 1 or higher

Application area

The Helmholz Ethernet Switch 16-port, unmanaged is suitable for installation on a DIN rail and connects
up to 16 Ethernet participants with 10, 100 or 1000 Mbps.

Connections

The Ethernet Switch 16-port has 16 RJ45 connections. The Ethernet Switch 16-port must be supplied with
24 V DC at the 18 - 30 V wide range input via the provided connector plug. The terminal (FE,
functional ground. Connect this correctly with the reference potential.

Features

-
Store-and-Forward architecture
-
10BASE-T/100BASE-TX/1000BASE-T
-
Full-/Half-Duplex
-
Auto negotiation
-
Auto MDI/MDI-X (IEEE 802.3u Auto crossover support)
-
QoS-Priority-Queues: 8
-
LLDP & PTCP Delay-Traffic blocking (for PROFINET networks)
-
2x 16K MAC address lookup table
-
2x 256 Kbyte memory for frame buffering
-
Up to 51 Gbps high-performance memory bandwidth
-
support Jumbo frame sizes up to 10Kbyte

LEDs

PWR Led On = Power supply present
Off = No voltage or the device is defective
RJ45 LEDs
Orange (Link/Activity):
Green (Speed):
Attention: If the device is used in a manner not specified by the manufacturer, the protection
provided by the device may be affected. Pay special attention to the correct contact during cable installation.
If you have problems, always read the latest documentation first, which can be found on the Internet at
www.helmholz.com. Connected circuits shall meet the requirements of Limited energy circuits acc. UL61010-1.
Helmholz GmbH & Co. KG | Hannberger Weg 2 | 91091 Großenseebach
Phone +49 9135 7380-0 | Fax +49 9135 7380-490 | info@helmholz.de |
On or Blinks = Data transmission
On = 1000 Mbps Blinks = 100 Mbps Off = 10 Mbps
www.helmholz.de
) is for the
BT-beipack-169
2021-02-12