Wiring Harness - BRP Can-Am Freedom Trailer User Manual

rmo2015-007-014_a
1. Position lights (LH side view)
2. Taillights (LH side view)
1. Remove screws securing position
light in place.
2. Pull out the position light.
3. Insert wires of the new position light
through the trailer body hole.
4. Connect the connectors (match
color).
5. Secure the light on trailer body with
previously removed bolts and nuts.
6. Tighten screws to the specified
torque.
TIGHTENING TORQUE
Position light
nuts
License Plate Light Replacement
The licence plate light is built with
LEDs (light emitting diode) and this
technology proved to be reliable. In
the unlikely event they do not work,
have them checked by an authorized
Can-Am roadster dealer.

Wiring Harness

Wiring Harness Inspection
Check trailer harness and connector
for damages. Repair or replace as re-
quired.
Wiring and Connector Identification
When making wiring or connector re-
pairs on trailer connector, refer to illus-
tration below to identify the appropri-
ate and necessary connections.
1.75 N•m ± 0.25 N•m
(15 lbf•in ± 2 lbf•in)
rmo2015-007-017_a
1. WH=WHITE (ground)
2. BR=BROWN (position lights/tail light)
3. YL=YELLOW (LH brake/turn signal)
4. GN=GREEN (RH brake/turn signal)
5. WH=WHITE (ground)
6. BR=BROWN (position lights/tail light)
_______________
MAINTENANCE PROCEDURES
BR
WH
3
2
1
3 4
4
GN
YL
2
1
5
6
27