Wheel Bearing Seal; Lights - BRP Can-Am Freedom Trailer User Manual

MAINTENANCE PROCEDURES
Wheel Hub Removal
NOTE: Bearings are not available as
spare parts. When bearing replace-
ment is required, replace wheel hub as
an assembly.
1. Install a jack under trailer frame.
NOTICE
Make sure to place the
jack under frame and not under
trailer shell. Severe damage will oc-
cur if the trailer is raised by its shell.
2. Remove the wheel.
3. Remove the protective cap.
4. Remove the wheel hub nut and
washer. Discard nut.
rmo2015-007-011_a
1. Protective cap
2. Wheel hub nut (discard) and washer (keep)
5. Remove the wheel hub from the
spindle and discard it.
Wheel Hub Installation
1. Apply grease on spindle when rub-
ber seal meets spindle.
rmo2015-007-012_a
1. Spindle
2. Place hub on the spindle and secure
it loosely using the hub nut and its
washer.
______________
26
rmo2015-007-013_a
1. Wheel hub
2. Spindle
3. Apply final tightening torque
FINAL TIGHTENING TORQUE
Wheel hub
nut

Wheel Bearing Seal

Wheel Bearing Seal Inspection
Check if the seal is damaged replace
wheel hub if needed.

Lights

Rear Light Module Replacement
The rear light modules are built with
LEDs (light emitting diode) and this
technology proved to be reliable. In
the unlikely event they do not work,
the rear light module must be re-
placed completely. See an authorized
Can-Am Spyder dealer.
Position Light Replacement
The position lights are built with LEDs.
The complete light must be replaced.
LEDs are not available separately.
290 N•m ± 10 N•m
(214 lbf•ft ± 7 lbf•ft)