Connecting Trailer Lights - BRP Can-Am Freedom Trailer User Manual

rmo2010-005-015_a
1. Left safety chain attaches on right side of
hitch
2. Right safety chain attaches on left side of
hitch

Connecting Trailer Lights

NOTICE
To
wiring harness, ensure the harness
does not pass between chains.
1. Remove the protective cap from ve-
hicle connector.
rmo2013-007-013_a
RT MODEL SHOWN
1. Vehicle connector
2. Protective cap
NOTE: On Spyder RT models, the ve-
hicle connector is located on the LH
side of vehicle, under the rear side
storage compartment. On Spyder ST
models, the vehicle connector is lo-
cated on the RH side of vehicle close
to the muffler.
CAUTION Be careful not to
touch the muffler when reaching
for vehicle connector.
avoid damaging
2. Align trailer connector with vehicle
connector.
rmo2013-007-001_a
RT MODEL SHOWN
1. Vehicle connector
2. Trailer connector
3. Connect trailer connector to vehicle
connector by firmly squeezing them
in place. Make sure they are well
secured into one another, if needed,
lubricate the tips. Place protective
cap on specially designed hump,
see illustration below for reference.
rmo2013-007-024_a
ST MODEL SHOWN
_______________
ATTACHING YOUR TRAILER
13