Table of Contents
Advertisement
Installation
Drainage connection
See the separate installation instructions for all
necessary information.
This dishwasher is suitable for installing in a raised
recess (to attain an ergonomic working height). This
means that the dishwasher can be placed so that the
drainage hose runs to a lower level than the bottom of
the dishwasher, such as by routing it directly to a floor
drain. The dishwasher is fitted with an integrated
anti-siphon device to prevent the machine from being
emptied of water during the wash cycle.
The drainage hose can also be connected to a
connection nipple on the sink unit's water trap. The
connection nipple must have an internal diameter of at
least 14 mm.
The drainage hose may be extended by a maximum of
3 m (the total length of the drainage hose must not
exceed 4,5 m). Any joins and connecting pipes must
have an internal diameter of at least 14 mm. However,
the drainage hose should ideally be replaced with a new
hose without joins.
No part of the drainage hose may be more than 950 mm
above the bottom of the dishwasher.
Ensure that the drainage hose has no kinks.
Connection to water supply
Use only the supply hose provided with the dishwasher.
Do not re-use old hoses or other spare supply hoses.
The supply pipe must be fitted with a stopcock. The
stopcock must be easily accessible, so that the water
can be shut off if the dishwasher has to be moved.
Once the installation is complete, the stopcock should
be opened to allow the pressure to settle for a while and
to check that all connections are tight.
Connect to cold water...
If you use oil or electricity to heat your home.
Connect to hot water (max. 70 °C)...
If you use district heating, solar power or geothermal
power to heat your home. Choosing a hot water
connection cuts programme times and reduces the
dishwasher's electricity consumption.
38
Electrical connection
Information about the electrical connection can be found
on the serial number plate This specification must match
the electricity supply.
Dishwashers fitted with a plug must be connected to an
earthed socket.
The electric wall socket must be placed outside of the
installation area to be easily accessible after installing
the dishwasher. Do not use an extension cord!
NOTE!
Repairs and maintenance relating to safety or
performance must be carried out by a qualified
professional.
Advertisement
Table of Contents
