Acqiris SA230E User Manual page 94

10.1 Safety notes
circumstances must be trained to protect themselves from the risk of electric shock. If the circuit is
capable of operating at or above 1000 V, no conductive part of the circuit may be exposed.
Do not connect modules directly to unlimited power circuits. They are intended to be used with
impedance-limited sources. NEVER connect modules directly to AC mains. When connecting
sources to modules, install protective devices to limit fault current and voltage to the module.
Before operating a module, ensure that the line cord is connected to a properly-grounded power
receptacle. Inspect the connecting cables, test leads, and jumpers for possible wear, cracks, or
breaks before each use.
When installing equipment where access to the main power cord is restricted, such as rack mounting,
a separate main input power disconnect device must be provided in close proximity to the equipment
and within easy reach of the operator.
For maximum safety, do not touch the product, test cables, or any other instruments while power is
applied to the circuit under test. ALWAYS remove power from the entire test system and discharge
any capacitors before: connecting or disconnecting cables or jumpers, installing or removing ADC
modules, or making internal changes, such as installing or removing jumpers.
Do not touch any object that could provide a current path to the common side of the circuit under test
or power line (earth) ground. Always make measurements with dry hands while standing on a dry,
insulated surface capable of withstanding the voltage being measured.
The module and accessories must be used in accordance with its specifications and operating
instructions, or the safety of the equipment may be impaired.
Do not exceed the maximum signal levels of the modules and accessories, as defined in the
specifications and operating information, and as shown on the module or test fixture panels, or ADC
module.
If you are using a test fixture, keep the lid closed while power is applied to the device under test. Safe
operation requires the use of a lid interlock.
Cards and accessories shall not be connected to humans.
Before performing any maintenance, disconnect the line cord and all test cables.
Any part or component replacement must be done by Acqiris.
No operator serviceable parts inside. Refer servicing to qualified personnel. To prevent electrical
shock do not remove covers.
94 Acqiris SA230E User's Manual