Solid State Output; User Interface Menu Abbreviations Defined - Veris Industries E50C A Series Installation Manual

Installation Guide
Power Monitoring
E50B1A, E50C2A, E50C3A

Solid State Output

User Interface (UI)
Menu Abbreviations
Defined
ZL0116-0A Page 11 of 26
Alta Labs, Enercept, Enspector, Hawkeye, Trustat, Aerospond, Veris, and the Veris 'V' logo are trademarks or registered trademarks of Veris Industries, L.L.C. in the USA and/or other countries.
The E50xxxA have one normally open (N.O.) KY Form A output and one normally closed (N.C.) output.* One is dedicated to energy
(Wh), and the other to Alarm. The E50B1A also provides an additional N.O. reactive energy (VARh) contact. See the Setup section
for configuration information.
Over-Current Protective
Device** (not supplied)
E50B1A only
+ – S
Alarm Energy Output
The solid state pulse outputs are rated for 30VAC/DC nom.
Maximum load current is 100mA at 25°C. Derate 0.56mA per °C above 25°C.
* While the relay used for the Phase Loss contact is Normally Closed (contacts are closed when the meter is not powered), closure indicates the presence of an
alarm; either loss of phase, when the meter is powered, or loss of power when the meter is not. The contacts are open when the meter is powered and no phase
loss alarm conditions are present
** The over-current protective device must be rated for the short circuit current at the connection point.
The user can set the display mode to either IEC or IEEE notation in the SETUP menu.
Main Menu
IEC IEEE
D D Demand
MAX M Maximum Demand
P W Present Real Power
Q VAR Present Reactive Power
S VA Present Apparent Power
A A Amps
UAB, UBC, UAC VAB, VBC, VAC Voltage Line to Line
V VLN Voltage Line to Neutral
PF PF Power Factor
U VLL Voltage Line to Line
HZ HZ Frequency
KSh KVAh Accumulated Apparent
Energy
KQh KVARh Accumulated Reactive
Energy
KPh KWh Accumulated Real Energy
PLOSS PLOSS Phase Loss
LOWPF LOWPF Low Power Factor Error
©2013 Veris Industries USA 800.354.8556 or +1.503.598.4564 / support@veris.com
Other companies' trademarks are hereby acknowledged to belong to their respective owners.
≤ 100 mA
Power Source
~
= 3-30 VDC
LOAD
6-30 VAC
≤ 100 mA
Power Source
~
3-30 VDC
=
6-30 VAC
LOAD
≤ 100 mA
Power Source
~
3-30 VDC
=
LOAD
6-30 VAC
Description
F ERR
I OVR
V OVR
PULSE
_PHASE
ALERT
INFO
MODEL
OS
RS
SN
RESET
PASWD
ENERG
DEMND
Main Menu
IEC IEEE Description
F ERR Frequency Error
I OVR Over Current
V OVR Over Voltage
PULSE kWh Pulse Output Overrun
(configuration error)
_PHASE Summary Data for 1, 2, or 3
active phases
ALERT Diagnostic Alert Status
INFO Unit Information
MODEL Model Number
OS Operating System
RS Reset System
SN Serial Number
RESET Reset Data
PASWD Enter Reset or Setup
Password
ENERG Reset Energy Accumulators
DEMND Reset Demand Maximums
TM
07132