CombiPLUS Kit for Vitodens 100-W, WB1B Quick Start
Connecting the CombiPLUS Piping
N
L
J
I
2
N
1
L
A
A
J
I
Connecting the CombiPLUS A using the
supplied piping, adaptors and mounting
hardware.
1
Install the adaptors N to the tees at the
bottom of the boiler.
Install the flex pipes L to the adaptors N.
Carefully form the flex pipes L to align
with the extension fittings on the top of
the CombiPLUS A.
Note:The flex pipes L must be bent due
to offset in the fittings between the
boiler and the CombiPLUS.
The nominal length of the 7" flex pipe
after bending is 6b" a".
Slide the CombiPLUS A up and install
the flex pipes L to the extension fittings
of the CombiPLUS A.
IMPORTANT
DO NOT overtighten the flex pipe fittings.
When connecting the flexible pipes do not
overtighten the hex nuts. This is a gasketed
design and should be hand tightened plus b
turn with a wrench.
2
Tighten the two lag bolts located in the
CombiPLUS A mounting bracket slots.
Install the supplied washers J on to the
lag bolts I.
Install the lag bolts/washers through the
upper mounting holes of the CombiPLUS
A mounting bracket and into the wall
anchors (if used) and tighten.
Installation
7