Table of Contents
Advertisement
SET UP & USE
PREPARE THE WINDOW
through the condenser, for heat removal. The rear of the unit must be outdoors, not inside
a building or garage.
PREPARE AIR CONDITIONER
Use 2 people to lift.
B: Remove top rail from the packaging material as shown in Fig. A.
This device complies with part 15 of the FCC rules. Operation is subject to the following two
conditions: 1) This device may not cause harmful interference, and 2) This device must accept any
interference received, including interference that may cause undesired operation. This equipment has
been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the
FCC rules. These limits are designed to provide reasonable protection against harmful interference in
a residential installation. This equipment generates, uses and can radiate radio frequency energy and,
if not installed and used in accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that the interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or television reception, which
can be determined by turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures: a) Reorient or relocate the receiving antenna.
b) Increase the separation between the equipment and the receiver. c) Connect the equipment into
an outlet different from that which the receiver is connected. d) Consult the dealer or an experienced
radio/TV technician for help.
Page 10
MOUNTING HARDWARE
(For Wooden
windows)
3/4" (or 1/2")
3/ 4 (or 1/
2 )
Lock Frame
Screws
Screws
(2)
(7)
(7)
TOP RAIL HARDWARE
Fig. A
3/8 Screws
(4)
3/8 Screws
(4)
Packaging
Packaging
(For Vinyl-Clad
windows)
(For Wooden
(For Vinyl-Clad
(on some models)
windows)
windows)
(on some models)
Lock Frame
Sash Lock
Lock Frame
Lock Frame
Sash Lock
(2)
(2)
(2)
Top Rail
(1)
Top Rail
(1)
Fig.A
Top Rail
R1 hardware(for
Top Rail
>
10000Btu/h models
only
3/ 4 (or 1/
2 )
3/ 4 (or 1/
2 )
Screws
Screws
(7)
(7)
Window sash
Window sash
(1)
(1)
seal foam
seal foam
(1)
(1)
3/ 4 (or 1/
Screws
Weather stripping
(7)
(10 *3/4 *1/12 )
(5)
3/8 Screws
Weather stripping
3/8 Screws
(4)
(4)
(10 *3/4 *1/12 )
(5)
R1 hardware
(2)
3/8 Screws
Packaging
Packaging
R1 hardware
(for <
10000
Btu/h models
only
)
Packaging
)
(For Wooden
(For Vinyl-Clad
(For Wooden
(For Vinyl-Clad
windows)
windows)
windows)
windows)
(on some models)
(on some models)
Lock Frame
Lock Frame
Lock Frame
Lock Frame
(2)
(2)
(2)
(2)
(For Wooden
(For Vinyl-Clad
windows)
windows)
(on some models)
2 )
Lock Frame
Lock Frame
(2)
(2)
Top Rail
Top Rail
(1)
(1)
Fig.A
Fig.A
Top Rail
R1 hardwar
(4)
Top Rail
R1 hardware
Top Rail
>
>
10000Btu/
only
only
Top Rail
Sash Lock
Sash Lock
W
(1)
(1)
Weather
Weather
(10 *3/4
Sash L
(10 *3/4 *
(
(1)
(5
R1 h
R1 ha
(
Wea
R1 h
(1
R1 ha
(for <
(for <
Btu/h
Btu/h
only
only
)
(1)
10000Btu
)
Fig.A
)
R
(f
B
o
R1 hard
>
10000
only
)
Advertisement
Table of Contents
Troubleshooting
