Huawei AP6510DN-AGN-US Quick Start Manual page 5

Installing an AP
● Select an appropriate installation position and leave space above and around the device for cooling air circulation.
● Outdoors Aps are used for hotspot coverage and often installed against walls or poles. The pole diameter is 48 mm to 114 mm.
AP6510DN-AGN-US dimensions (unit: mm) without a backplane
support.
330
● Installing the AP6510DN-AGN-US against a Wall:
1. Fix the wall-mounting bracket to the wall, adjust the
installation position, and use the marker, level, and
measuring tape to mark the drilling positions where
expansion bolts are installed.
64mm
3. Use four M4*12 hexagon socket head cap screws to fasten the wall-mounting bracket to the AP.
4. Pinch the wall-mounting bracket on the expansion
bolts, and fasten the flat washer, spring washer, and
nuts in order.
Field strength
场强示意
Recommended AP6510DN-AGN-US installation space
(unit: mm).
83
2. Use #8 drill bit to drill 35 mm to 40 mm deep holes in the
drilling positions and install expansion bolts. Screw the nut
into the expansion tube, hammer the expansion bolt into a
hole until the flat washer is flattened against the wall, and
remove the nuts, spring washer, and flat washer in order.
Hexagon
socket head
cap screw
5. Slide the AP into the wall-mounting bracket to complete
installation.
4
Flat washer
Spring washer
Nuts