Pure Fun 9301AK Product Manual page 5

ASSEMBLY INSTRUCTIONS
1. Locate 4 legs of the trampoline to install
the wind stakes. In order to keep the
trampoline properly grounded you must
place stakes evenly distributed around the
trampoline as pictured to the right.
EXAMPLE:
Locate Letters A, B, C, & D on the image
shown as an example of where the Wind
Stakes can properly be attached.
2. Once you have chosen the locations you
wish to install the Wind Stakes to, locate
the middle of the U-Shaped Leg and point
the legs of the Stakes towards the ground.
The legs of the Wind Stakes must be
separated, this will allow the arch to secure
the trampoline.
3. Using a rubber mallet, hammer the Stake
into the ground by hitting the upper knob
of the Wind Stake. Do this until the arch is
touching the leg of the U-Shaped Leg.
NOTE:
Do not use any tool other than a rubber
mallet to hammer the Wind Stake into
the ground, failure to do this will break or
crack the product.
4. Repeat Steps 1-3 until all Wind Stakes
have been successfully secured into
their respective U-Shaped Legs of the
Trampoline.
Model# 9301AK
1
A
C
2
3
A
B
D
C
Side View
B
D
Top View
5