Pairing Errors - AT&T U-verse Manual

2.6 Pairing Errors

These errors are displayed as overlays over the screen that initiated the error.
If the PIN entered by the user is
incorrect, display this error.
On tap, the Try Again button displays
the Add Receiver (
Figure 2-3)
Figure
If there was an error in connecting to
the STB after several attempts, display
this error.
On tap, the Dismiss button displays the
My U-verse Receivers screen (
Figure
© 2013 AT&T Intellectual Property. All rights reserved. AT&T and the AT&T logo are trademarks of AT&T Intellectual Property.
or Add New Receiver (
2-4) screens.
2-2).
Error Code 2-1: Pairing Errors
Page 14 of 16
If user taps on the Next button in the
Add New Receiver screen before the
STB connection mode has been set,
display the following error: STB
connection mode not set:
On tap, the Dismiss button displays the
Add New Receiver (
Figure 2-4) screen.
If the user sets the connection mode to
"disabled" during the setup wizard,
display this error.
On tap, display the My U-verse
Receivers screen (
Figure 2-2) without the corresponding
receiver listed.