Adobe 65021048 User Manual page 67

Capture with device control
After a device and the project are set up properly, you can begin capturing clips using device control. You can capture
an entire tape or you can mark In and Out points for each clip, and then capture the clip. You can log In and Out
points for any number of clips and have Adobe Premiere Pro capture as many as you like in a batch. Adobe Premiere
Pro supports FireWire device control on both platforms, but supports serial device control on Windows only.
Note: On Mac OS, you must preview HDV footage on an external TV monitor, or, if the source is a camcorder, on the
camcorder viewfinder while shuttling, logging, and capturing. The preview pane in the Capture panel will show the
words Previewing On Camera.
See also
"Set up device control" on page 58
Capture an entire tape
Choose File > Capture.
1
2 (Mac OS) If a QuickTime Capture Settings dialog box opens, choose video and audio settings appropriate to your
project.
These settings will be preserved for the project, but you may need to set them again for each new project.
In the Capture panel, make sure that the device is online, as indicated above the preview.
3
Insert a tape into the device. Adobe Premiere Pro prompts you to name the tape. Be sure not to give any two tapes
4
the same name.
Including a unique number in the name can help you avoid using the same name twice.
5 In the Setup area of the Logging pane, choose the media type from the Capture pop-up menu.
Rewind the tape to its beginning.
6
7 If you want to create a separate file (Windows) or a subclip (Mac OS) for each new scene on the tape, select Scene
Detect in the Capture area (not available for HD or HDV footage).
If you want to capture frames that extend beyond the In and Out points of each clip, enter the number of frames
8
in the Handles box in the Capture area.
Click Tape.
9
Select and capture a clip
Choose File > Capture.
1
2 (Mac OS) If a QuickTime Capture Settings dialog box opens, choose video and audio settings appropriate to your
project.
These settings will be preserved for the project, but you may need to set them again for each new project.
In the Capture panel, make sure that the device is online, as indicated above the preview.
3
4 Insert a tape into the device. Adobe Premiere Pro prompts you to name the tape. Be sure not to give any two tapes
the same name.
In the Setup area of the Logging pane, choose the media type from the Capture pop-up menu.
5
6 Use the controls in the Capture panel to move to the first frame you want to capture, and click Set In. Then move
to the last frame you want to capture, and click Set Out.
April 1, 2008
ADOBE PREMIERE PRO CS3 61
User Guide