Adobe 65021048 User Manual page 54

Start Adobe Premiere Pro, and, on the Welcome screen, click New Project.
5
In the Load Preset panel of the New Project dialog box, select the DV or HDV preset that matches the format of
6
your source footage.
7 Browse to a location, and type a name for the project file. Then click OK.
See also
"About projects" on page 21
Set up an SD-SDI, HD-SDI, or component system
A B
SDI/component setup with breakout box
A. Computer and computer monitor B. A/V breakout box C. XLR jacks and plugs for L & R audio D. RS232/422 port and connector
E. BNC jacks and plugs for Y/Pb/Pr component video, BNC jack and plug for SDI video F. HD/SD VTR G. BNC jacks and plugs for Y/Pb/Pr
component video, BNC jack and plug for SDI video H. RCA jacks and plugs for L (white) & R (red) audio I. Speakers J. Television monitor
With this setup you can capture audio and video from an SD-SDI, HD-SDI, or component video device (camcorder
or VTR), monitor the signal on a TV monitor while editing, and export any sequence back to the camcorder or VTR.
This setup requires either an SDI or component PCI card installed in the computer, or an external SDI or
component device connected to the computer via FireWire. Either of these would provide ports, usually with BNC
connectors, capable of receiving SDI or component video signals.
Some SDI and component PCI cards come with breakout boxes which provide ports for the SDI or component
signals, and sometimes also ports for genlock, in an easy-to-access array.
Connect the SD-SDI, HD-SDI, or component device to the computer or breakout box using SDI or component
1
video cables. A single cable with BNC connectors carries SDI video, but three separate cables with BNC connectors
carry component video signals. Run video cables from the video outputs of the computer or breakout box to the
video inputs of the device. Also run video cables from the video outputs of the device to the video inputs of the
computer or breakout box.
2 Connect the SD-SDI, HD-SDI, or component device to the computer or breakout box using XLR audio cables.
Run audio cables from the audio outputs of the computer or breakout box to the audio inputs of the device. Also
run audio cables from the audio outputs of the device to the audio inputs of the computer or breakout box.
D
F
C E
April 1, 2008
I
H
J
G
ADOBE PREMIERE PRO CS3 48
User Guide