Non-Optoisolated Rear I/O Module - PEP Modular Computers CP345 Manual

Quad high-speed serial controller board
Table of Contents

Advertisement

CP345
Operating Systems
The CP345 and its rear I/O modules can operate under the following operating systems:
©
Windows
©
QNX
©
VxWorks
Drivers are supplied for these operating systems.

5.1 Non-Optoisolated Rear I/O Module

The CP-RIO-345 rear I/O module is a high speed, 4-channel serial I/O device support-
ing the RS232, RS422 and RS485 industry standards. The CP-RIO-345 is provided with
the following key features.
32-bit CompactPCI board, 33 MHz
Up to 1 MBaud asynchronous transmission
4 independent serial channels
RJ45 connector block (one connector for each channel)
RS232, RS422, and RS485 standards
Each channel individually programmable per software
Bus termination resistors (RS422/RS485) software selectable
Control LED's both on the module's and mainboard's frontpanels
Jumperless configuration
Windows NT
The supply voltage for the module is 5V DC.
Page 5 - 8
NT 4.0
, QNX
and VxWorks
®
®
© PEP Modular Computers GmbH
Rear I/O Modules
drivers
®
ID 19979, Rev. 03

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the CP345 and is the answer not in the manual?

Table of Contents