Shaver HD-10 Operator's Manual page 19

4. Apply a light film of a good quality grease
to the pivot shaft and attach roller bracket
(I6) to swing arm handle (I5) with roller
bracket nut (I9). Tighten nut until seated
and then loosen 1/4 to 1/2 turn.
NOTE: Roller bracket (I6) must swivel freely
on swing arm handle (I5).
(I5) Swing Arm Handle. (I6) Roller Bracket. (I9) Roller
Bracket Nut.
5. Attach one end of latch spring (I10) to
swing arm handle (I5), as shown. Secure
with spring retainer flat washer (I11) and
Lynch pin (I13).
(I5) Swing Arm Handle. (I10) Latch Spring. (I11) Spring
Retainer Flat Washer. (I13) Lynch Pin.
6. Install the swing arm assembly.
a. Apply a light film of a good quality
grease to the pivot shaft on swing arm
handle (I5).
b. Start the pivot shaft into the main
bracket tube, as shown. Slide the open
spring eye over the main bracket
anchor rod.
NOTE: Swing arm handle (I5) will be below
safety arm frame (I2) bracket stop at this
point.
c. Secure spring with flat washer (I11)
and Lynch pin (I13).
(I11) Flat Washer. (I13) Lynch Pin.
19 19