Hydraulic Valve - Shaver HD-10 Operator's Manual

NOTE: If using manual base plate (E2)
assembly, adjust forward tilt crank (E11) and
side tilt crank (E3) to align channel mounting
pin holes. Install lower channel mounting pin
(D6) first and then upper channel mounting
pin. Secure pins with Lynch pins (included).
(D6) Channel Mounting Pin. (E2) Manual Base Plate.
(E3) Side Tilt Crank. (E11) Forward Tilt Crank.

Hydraulic Valve

The customer must supply suitable hydraulic
quick disconnect fittings for connecting
pressure supply hose (G17) and return hose
(G20) to the tractor or power supply hydraulic
system.
IMPORTANT NOTICE
Hydraulic system fittings that require a thread
sealant must be installed with a paste-type
sealer only. Do not use a tape-type sealer, such
as Teflon Tape, as this can contaminate the
system and voids the valve warranty.
1. Assemble the hydraulic control valve.
Single lever control valve (G1) for manual
base plate or triple lever control valve (H1)
for hydraulic base plate.
a. Remove the plugs from the hydraulic
control valve. Apply paste-type thread
sealant (T12) to pipe threads and
install hydraulic fittings (G16, G18,
G19, G21), and on triple lever control
valve, four tilt cylinder hose fittings
(H3). Refer to photographs for correct
placement and orientation.
(G1) Manual Tilt Base Control Valve.
(H1) Hydraulic Tilt Base Control Valve.
(G16) Swivel Fitting:
3/4" O-Ring Male to 1" Female NPT.
(G19) 90° Swivel Fitting:
1-1/16" O-Ring Male to 1/2" Female.
(G21) 90° Swivel Fitting:
3/4" Male to 1" NPT Female with
Adapter Fitting:
1-1/16" O-Ring Male to 3/4" NPT Female.
(H3) 90° O-Ring Swivel Fitting (with restrictor):
7/8" Male to 1/4" Female.
13