Rubber Debris Guard - Shaver HD-10 Operator's Manual

3. To adjust the safety stop, do the following:
a. Squeeze the control valve lever and the
control valve safety lever together to
expose the safety lever stop setscrew.
b. Insert a 1/8" Allen wrench and adjust
the setscrew outward
(counterclockwise) slightly. Remove
the Allen wrench and repeat Step 1.
Adjust the Safety Stop Setscrew.
c. If necessary, repeat Step 3a and
Step 3b until the setscrew prevents
more than 1/4" of forward movement of
the control valve lever.
NOTE: Do not "over adjust" the setscrew.
Make sure the setscrew easily falls into place
behind the lip on the control valve when it is
released quickly (1/8" gap at the setscrew).
Gap Between Setscrew and Valve Body.

Rubber Debris Guard

1. Locate rubber debris guard (A4), guard
mounting strap bracket (A5), and bag
containing hardware and caution tag
(A6, A7, A8, and A9).
(A4) Rubber Debris Guard. (A5) Guard Mounting Strap
Bracket. (A6) Caution Tag. (A7) Bolt. (A8) Lock Washer.
(A9) Nut.
2. Attach rubber debris guard, mounting
strap, and caution tag on drive ram (A1)
with guard mounting bolts, lock washers,
and nuts, as shown.
NOTE: To avoid damage to the rubber debris
guard, do not over-tighten the mounting
hardware.
(A1) Drive Ram.
17