Table of Contents
Advertisement
POWER FACTOR CONTROLLER
PFC6DA
1. BUTTONS AND INDICATION LEDs
2. DESCRIPTION
3. OPERATION
4. ELECTRICAL DIAGRAM FOR INSTALLATION
5. SET-UP MENU
6. SETTING PASSWORD
7. SETTING AUTORECOGNIZED CAPACITOR BANK
8. MEASUREMENTS FUNCTIONS
9. COS AND SENSITIVITY SET-UP
10. OPERATION MODE
11. ALARMS TABLE
12. TECHNICAL DATA
13. TERMINAL CONNECTIONS
14. DIMENSIONS
AVAILABLE OPTIONAL COMMUNICATION MODULE PC-USB / RS485 / TTL - ORDER CODE: SCUSB485
REGISTERS MODBUS-RTU TABLE ON REQUEST
I
!!! IMPORTANT !!! READ THE INSTALLATION MANUAL BEFORE USE.
THE SAFETY OF THE PRODUCT IS STRICTLY RELATED TO ITS USE THAT HAS
TO BE DONE AS SPECIFIED BY THE MANIFACTURER.
TECHNICAL MANUAL OF INSTALLATION
PFC8DB
INDEX
1 / 16
PFC12DB
> Pg. 2
> Pg. 2
> Pg. 2
> Pg. 3
> Pg. 4
> Pg. 7
> Pg. 7
> Pg. 8
> Pg. 9
> Pg. 9
> Pg. 10
> Pg. 11
> Pg. 15
> Pg. 15
SPT-DPFC1PH_EN-MAN_3.2_14-02-2014 - FW 12.9 / 9.6
ETI Elektroelement d.d. - Slovenija
Tel.: 03/56-57-570- Fax: 03/56-74-077
www.eti.si - eti@eti.si
Advertisement
Table of Contents
Related Manuals for ETI PFC6DA
Summary of Contents for ETI PFC6DA
- Page 1 THE SAFETY OF THE PRODUCT IS STRICTLY RELATED TO ITS USE THAT HAS TO BE DONE AS SPECIFIED BY THE MANIFACTURER. SPT-DPFC1PH_EN-MAN_3.2_14-02-2014 - FW 12.9 / 9.6 1 / 16 ETI Elektroelement d.d. - Slovenija Tel.: 03/56-57-570- Fax: 03/56-74-077 www.eti.si - eti@eti.si...
-
Page 2: Operation
(5.1 - Basic Set-up Menu). Pressing button the respective outputs and the LED will be activated, letting you test the connections. 2 / 16 ETI Elektroelement d.d. - Slovenija Tel.: 03/56-57-570- Fax: 03/56-74-077 www.eti.si - eti@eti.si... - Page 3 Q1 - The installer has to provide an external disconnection device; this breaker has to be easily reachable and identified as "disconnection device". ) - The value has to be calculated according to the T1 used. 3 / 16 ETI Elektroelement d.d. - Slovenija Tel.: 03/56-57-570- Fax: 03/56-74-077 www.eti.si - eti@eti.si...
-
Page 4: Device Startup
Therefore it will be necessary to program again all the parameters on the Basic set-up menu. For a quick exit from the menu, press for 3 seconds until display shows 4 / 16 ETI Elektroelement d.d. - Slovenija Tel.: 03/56-57-570- Fax: 03/56-74-077 www.eti.si - eti@eti.si... - Page 5 Therefore it will be necessary to program again all the parameters on the Advance Menu. For a quick exit from the menu, press for 3 seconds until display shows 5 / 16 ETI Elektroelement d.d. - Slovenija Tel.: 03/56-57-570- Fax: 03/56-74-077 www.eti.si - eti@eti.si...
- Page 6 5 seconds, on display will shows Now the device will restart. ATTENTION: All settings made on the device will be lost and all steps will be restored to default setting. 6 / 16 ETI Elektroelement d.d. - Slovenija Tel.: 03/56-57-570- Fax: 03/56-74-077 www.eti.si - eti@eti.si...
- Page 7 Therefore it will be necessary to program again all the parameters on the Alarm Menu. For a quick exit from the menu, press for 3 seconds until display shows 7 / 16 ETI Elektroelement d.d. - Slovenija Tel.: 03/56-57-570- Fax: 03/56-74-077 www.eti.si - eti@eti.si...
-
Page 8: Setting Password
When the instrument requires the password, you have 30secs to enter it, otherwise the system will return to the normal operation. p) To disable the password set the value , or in extreme cases carry out reset (5.3 - Set Default Parameters). 8 / 16 ETI Elektroelement d.d. - Slovenija Tel.: 03/56-57-570- Fax: 03/56-74-077 www.eti.si - eti@eti.si... - Page 9 Cos programmed. h) If no button is pressed for 30 seconds, the display will return to show the Cos of the installation. 9 / 16 ETI Elektroelement d.d. - Slovenija Tel.: 03/56-57-570- Fax: 03/56-74-077 www.eti.si - eti@eti.si...
- Page 10 > The time needed to turn ON the step relay depends on the time of Reconnection of the step. ( 10 / 16 ETI Elektroelement d.d. - Slovenija Tel.: 03/56-57-570- Fax: 03/56-74-077 www.eti.si - eti@eti.si...
-
Page 11: Manual Operation Mode
Cos of installation if the available capacitor is too big. The new Cos measure must be less than 1.00 with the capacitor is on. 11 / 16 ETI Elektroelement d.d. - Slovenija Tel.: 03/56-57-570- Fax: 03/56-74-077 www.eti.si - eti@eti.si... -
Page 12: Alarms Table
The frequency is checked only at power on. Display Low Cos 60sec When the Cos is lower than the value set on par. alternated with Cos value 12 / 16 ETI Elektroelement d.d. - Slovenija Tel.: 03/56-57-570- Fax: 03/56-74-077 www.eti.si - eti@eti.si... -
Page 13: Technical Data
- IEC EN 61000-4-5 - IEC EN 61000-4-6 - IEC EN 61000-4-11 - IEC EN 61000-6-2 - IEC EN 61000-6-4 - IEC EN 61010-1 - IEC EN 61010-2-030 13 / 16 ETI Elektroelement d.d. - Slovenija Tel.: 03/56-57-570- Fax: 03/56-74-077 www.eti.si - eti@eti.si... -
Page 14: Terminal Connections
* The 96x96 picture shows the TTL version (optional) 14 - DIMENSIONS: 96x96 - MODEL FRONT VIEW SIDE VIEW PANEL HOLE 144x144 - MODEL FRONT VIEW SIDE VIEW PANEL HOLE 14 / 16 ETI Elektroelement d.d. - Slovenija Tel.: 03/56-57-570- Fax: 03/56-74-077 www.eti.si - eti@eti.si... -
Page 15: Cleaning Of The Unit
If necessary clean the device with a soft cloth dampened with water. This operation must be done with the instrument switched off and disconnected from any power source. 15 / 16 ETI Elektroelement d.d. - Slovenija Tel.: 03/56-57-570- Fax: 03/56-74-077 www.eti.si - eti@eti.si... - Page 16 16 / 16 ETI Elektroelement d.d. - Slovenija Tel.: 03/56-57-570- Fax: 03/56-74-077 www.eti.si - eti@eti.si...
Need help?
Do you have a question about the PFC6DA and is the answer not in the manual?
Questions and answers