Table of Contents
Advertisement
Hot-swapping the ES Module
This section provides removal and installation instructions for
your Storage Enclosure's ES modules. For detailed information
about the ES module and how it works, see
page
3-2.
The ES module is located on the rear of the Storage Enclosure
between the two APCs, as shown in
The ES module is hot-swappable; removing the ES module does
not impact the data path.
Removing the ES Module
To remove the ES module from the Storage Enclosure:
1 Using a Phillips-head screwdriver, loosen the screw that
secures the module to the enclosure.
2 Grasp the ES module handle and gently pull the module from
the enclosure. Be sure to pull straight back and not to one side.
The cooling fans switch to high speed.
Warning: To avoid electrical shock, do not insert any
instruments or tools into the open ES module slot.
Installing an ES Module
To install an ES module in the Storage Enclosure:
1 With the handle toward you, slide the ES module straight into
the enclosure slot.
2 Gently push the module until the connectors engage.
3 Secure the module using the screw you loosened in
page
4-10. Hand tighten the screw. Do not over-tighten it.
The ES module automatically reboots and enclosure services are
reactivated. (See
Removing and Replacing Enclosure Components
Chapter 3, Monitoring
About the ES Module on
Figure 1-1 on page
for more information.)
1-4.
Step 1 on
4-10
Advertisement
Table of Contents
